
23
3.1.3
Flash Settings
This dialog is used to select and configure the flash device to operate with. The listed
options of the Flash settings menu are dependent on the selection in the CPU
settings dialog.
The menu should look similar to the screenshot below.
3.1.3.1 Base Address
You may enter the base address of the selected device. The default value is 0 which
fits for all STM8 devices.
3.1.3.2 Organization
You should select the buswidth and the number of flash chips connected to the
address and data bus of the MCU.
Normally this has not to be changed for STM8 devices.
3.1.3.3 Sector selection
The final section of this dialog indicates the sectors to be acted upon, whether they
are to be cleared, read back, or written. An individual or series of sectors may be
selected from the predetermined valid range.
J-Flash STM 8 (UM05007)
? 2004-2009 SEGGER Microcontroller GmbH & Co. KG